Parts designed by MakersCuenca (M-CU) or modified (Mod) in collaboration with healthcare professionals, to be 3d printed and used with medical equipment.
All parts should ALWAYS be used under the supervision of healthcare professionals. Theses parts were produced in order to help with the material deficit due to the situation caused by the COVID19 virus.
Theses parts were not approved and although a several number of them have been tested in hospitals and health centers, only the healthcare professionals must decide when and how these parts should be used, or if these parts should not be used at all depending on the circumstances.
DOWNLOAD MODELS AND PARTS INFO ( SPANISH FILE ):
DOWNLOAD DISINFECTION PROTOCOL ( SPANISH FILE ):
DOWNLOAD PARTS RESISTANCE TO DESINFECTION METHODS FILE:
| M-CU | - | PLA 0.2mm - 205ºC - 30mm/s |
22mm tested coupling - Not Certified model.
| M-CU | - | PLA 0.16mm - 200ºC - 30mm/s |
20 mm size flow meter regulates the pressure of the respiratory system - Not Certified model.
Modification of the original part that is connected to the Subea Easybreath mask. Models 1,2 and 3 for inhalation and upper exhalation (Isinova). Model 4 for use with Halo (exhalation through the lower part of the mask, currently is being tested. - Not Certified model.
| M-CU | - | PLA 0.16mm - 205ºC - 30mm/s |
Valve for use in respiratory circuits - Not Certified model.
Exhalation valve on Subea Easybreath diving mask, combined with Charlotte Halo (Charlottes Section -> File 4). Two versions, simple (thread without joint) and with joint (a joint is added between the thread and the polycarbonate to give more security ) - Not Certified model.